Manual Maestro MR655 Aparat de tuns

Manual

6 7

bath or sink.

- Do not use while bathing or in a shower.

- Do not place the appliance on any surface while it is operating.

- Never drop or insert any object into any opening on this appliance

WARNING! Do not use this appliance with a damaged or broken

comb nor with teeth missing from the blades as injury may occur.

- Before use, make sure certain blades are oiled and aligned

properly.

- Do not cut wet hair, before cutting dry and comb hair.

- Do not cut hair when there are dermatitis.

- Do not use this appliance for grooming pets.

THIS APPLIANCE IS FOR HOUSEHOLD USE ONLY. DO NOT

USE THE APPLIANCE FOR ANYTHING OTHER THAN INTENDED

USE.

- Do not use it for commercial purpose.

Actions in extreme situations

- If your device has fallen into water or water has penetrated it,

immediately disconnect it from the mains without contacting the

device itself or the water.

- If there appears smoke, sparkling, strong smell of burning

isolation, immediately stop using the device, disconnect the device

from the mains and apply to the nearest service center.

Operation

Before startup

- Remove all wrap materials and stickers

- Make sure that all the parts of appliance don’t have damages.

Blade alignment

- Your Clippers were carefully examined to ensure that the

blade were oiled and aligned before leaving our factory.

- Blades must be realigned if they have been removed for cleaning

or replacement.

- To realign the blades, simple match the upper and bottom

blades teeth up, point for point. (End of top blade teeth should

be approximately 1.2mm back from bottom blade. Compare your

clipper blade with the Picture 2 (page 2).

- If blade alignment is correct, add a few drops of oil to the blades,

turn clipper on for a few moments, turn off and unplug. Loosen

screws slightly and adjust. Tighten the screws after blade is aligned.

Oil

- To maintain your clipper in peak condition, the blades should be

oiled every few haircuts.

- Do not use hair oil, grease oil mixed with kerosene or any solvent,

as the solvent will evaporate and leave the thick oil which may slow

down the blades motion.

- Add a few drops of oil to the blades, turn clipper on for a few

moments, turn off and unplug. Wipe off any excess oil.

Blade lever

-The lever is conveniently located near your thumb (if you’re right-

handed) so it can readily be adjusted while the clipper is in your

hand.

-The lever adds versatility to your clipper by allowing you to

gradually change the closeness of your cut without an attachment

comb.

-When the lever is in the uppermost position, the blades will give

you the closest cut and -leave the hair very short. Pushing the lever

EN

Evaluare

Mai multe despre acest manual

Înțelegem că este plăcut să aveți un manual pe hârtie pentru Maestro MR655 Aparat de tuns. Puteți oricând descărca manualul de pe site-ul nostru web și îl puteți imprima singur. Dacă doriți să aveți un manual original, vă recomandăm să contactați Maestro. S-ar putea să ofere un manual original. Căutați manualul dvs. Maestro MR655 Aparat de tuns într-o altă limbă? Alegeți limba preferată pe pagina noastră de pornire și căutați numărul de model pentru a vedea dacă îl avem disponibil.

Specificații

Toate manualele pentru Maestro Aparate de tuns
Mai multe manuale pentru Aparate de tuns

Întrebări frecvente despre Maestro MR655 Aparat de tuns

Echipa noastră de asistență caută informații utile despre produs și răspunde la întrebările frecvente. Dacă descoperiți o inexactitate în întrebările frecvente, vă rugăm să ne anunțați utilizând formularul de contact.

Produse asemanatoare

Manual

Maestro MR650C Aparat de tuns

Manual

Maestro MR656 Aparat de tuns

Manual

Maestro MR650 Aparat de tuns

Manual

Maestro MR660 Aparat de tuns

Manual

Maestro MR652 Aparat de tuns

Manual

Maestro MR655C Aparat de tuns

Manual

Maestro MR651C Aparat de tuns

Manual

Maestro MR653C Aparat de tuns

Categorii relevante