Manual Tesy CN 03 100 MIS F Radiator

Ai nevoie de un manual pentru Tesy CN 03 100 MIS F Radiator? Mai jos puteți vizualiza și descărca manualul PDF gratuit în limba română. Acest produs are în prezent 2 întrebări frecvente, 0 comentarii și are 1 vot cu o evaluare medie a produsului de 100/100. Dacă acesta nu este manualul dorit, vă rugăm să ne contactați.

Produsul dvs. s-a defectat și manualul nu oferă nicio soluție? Mergeți la Repair Café pentru servicii de reparații gratuite.

Manual

Loading…

EN
Operation and Storage Manual of Panel Heater 3English
Position the panel heater with installed feet on the floor and before
connecting it to the power socket check if all instructions from the
very beginning of this manual have been followed correctly (Important
instructions and safety measures). The correct position is – the control
panel should be at the top of the appliance and the feet – on the floor!
BATHROOM OPERATION
The panel heater must be installed in accordance with the normal trade
practices and in compliance with the national legislation (EU electricity
directives and regulations concerning special installations and places of
operation including bathrooms, shower cabins HD60364-7-701(IEC 60364-
7-701:2006)).
In case this panel heater is to be used in a bathroom or other similar room,
the following installation requirements must be observed: the panel
heater is with IP24 protection (water drops protection). Hence it can be
installed in Volume 2” (see the diagram below) in order to avoid the risk of
the control board (power switch and thermo regulator) being reached by
a person who is in a shower or a bathtub. The minimum distance between
the appliance and a water source should be not less than 1 meter! If you do
not feel sure about the installation of this panel heater in a bathroom, we
recommend you to consult a professional electrician.
Note: If the above-mentioned instructions cannot be implemented, it is
recommended to install the appliance in “VOLUME 3”.
In wet premises the power source must be installed at a height of at least
25 cm above the floor (bathrooms and kitchens).
The installation must be equipped with a safety fuse, and the distance
between the fuse contacts in disconnected condition should be at least 3 mm.
Thank you for choosing CN03 panel heater. This is a product providing heating in
winter depending on the consumers needs for comfortable room temperature.
If operated and taken care of properly in accordance with these instructions, the
appliance will provide you with many years of useful operation.
OPERATION INSTRUCTIONS
MECHANICAL CONTROL
Operation modes
Turn the panel heater on by pushing the switch in position “I” (turned-on), then
turn the regulator to the desired level (1 to 6) as you take into account the
following relation between the power levels:
* – anti-freezing mode/ enabled when room temperature falls below 5°C
1 / 2 – economy mode/ it maintains low room temperature/ this mode is
recommended to be used at night and when there are no people present in
the room. This mode permits to maintain the set room temperature while
saving energy.
3 / 4 / 5 – comfort mode/ it maintains moderate room temperature/ this mode
is recommended to be used to maintain relatively high comfortable room
temperature during the day.
6 – maximum power mode / it maintains HIGH room temperature/ this mode is
recommended to be used when you need maximum high room temperature
Important: Thermo Regulator digits do not correspond to certain room
temperature levels, but they can be used by users to memorize the relation
between room temperature and the thermo regulator settings.
When the room temperature is lower than the temperature that you have set
by the thermo regulator, the panel heater starts its operation and will operate
until the room temperature reaches the set temperature level of the unit.
When the room temperature is higher than the adjusted temperature of the
appliance, the panel heater will automatically go into “Stand by mode.
PROTECTION
The appliance is
equipped with a safety thermo turn-off device, which
automatically turns the heater off in cases of extreme temperature of the
panel heater /i.e. overheating of the appliance/.
The safety thermo tur
n-off device will automatically restore the heater
operation when the temperature of the appliance falls below the
permissible ultimate values.
TIP-OVER PROTECTION
This heater is protected with a safety switch that turns off the appliance
automatically when the heater falls over, or is at an excessive angle from the
horizontal. This helps prevent accidents, and the heater will back to last set
mode when it is put back upright.
CLEANING
It is compulsory first to turn off the appliance through its power
switch and to disconnect it from the power socket. Before starting the
cleaning session you should wait until the panel heater cools down in a
disconnected state.
Clean the heater body with damp cloth, vacuum cleaner or a brush.
Never immerse the appliance into water – there is danger for your life from
electric shock!
Never use gasoline, thinner or hard abrasive products to clean the
appliance, because they will damage the appliance coating.
STORAGE
Before putting the panel heater away let it cool down after you have
disconnected it from the power socket
Use the appliance original packing to store it, if the panel heater will not
be in use for a long period of time. By storing the product in its original
packing you protect it from excessive dirt and dust accumulation.
Never put a hot panel heater in its packing!
It is necessary the product to be stored at a dry and dark place, protected
from direct sun light.
It is explicitly forbidden to store the panel heater in damp and wet premises.
MAINTENANCE OPERATIONS OF THE APPLIANCE
In case of appliance malfunction, please contact the authorized service
center closest to your location. /service centers are indicated in appliance
warranty documents/.
Descărcaţi manualul în limba română (PDF, 4.56 MB)
(Protejați mediul înconjurător și imprimați acest manual numai dacă este neapărată nevoie)

Loading…

Evaluare

Spuneți-ne ce părere aveți despre Tesy CN 03 100 MIS F Radiator, lăsând o evaluare a produsului. Doriți să împărtășiți experiența dvs. cu acest produs sau să adresați o întrebare? Lăsați un comentariu în partea de jos a paginii.
Ești mulțumit de Tesy CN 03 100 MIS F Radiator?
Da Nu
100%
0%
1 vot

Alăturați-vă conversației despre acest produs

Aici puteți împărtăși ce părere aveți despre Tesy CN 03 100 MIS F Radiator. Dacă aveți o întrebare, citiți mai întâi cu atenție manualul. Solicitarea unui manual se poate face folosind formularul nostru de contact.

Mai multe despre acest manual

Înțelegem că este plăcut să aveți un manual pe hârtie pentru Tesy CN 03 100 MIS F Radiator. Puteți oricând descărca manualul de pe site-ul nostru web și îl puteți imprima singur. Dacă doriți să aveți un manual original, vă recomandăm să contactați Tesy. S-ar putea să ofere un manual original. Căutați manualul dvs. Tesy CN 03 100 MIS F Radiator într-o altă limbă? Alegeți limba preferată pe pagina noastră de pornire și căutați numărul de model pentru a vedea dacă îl avem disponibil.

Specificații

Marcă Tesy
Model CN 03 100 MIS F
Categorie Radiatoare
Tip fișier PDF
Mărime fișier 4.56 MB

Toate manualele pentru Tesy Radiatoare
Mai multe manuale pentru Radiatoare

Întrebări frecvente despre Tesy CN 03 100 MIS F Radiator

Echipa noastră de asistență caută informații utile despre produs și răspunde la întrebările frecvente. Dacă descoperiți o inexactitate în întrebările frecvente, vă rugăm să ne anunțați utilizând formularul de contact.

Cum afectează praful eficiența unui încălzitor? Verificat

Praful se poate acumula pe elementele de incalzire si in filtrele de aer ale unui incalzitor, reducand randamentul acestuia. Acest lucru poate face ca încălzitorul să lucreze mai mult pentru a produce aceeași cantitate de căldură, ceea ce duce la un consum crescut de energie și la facturi mai mari la utilități. Pentru a menține eficiența încălzitorului, asigurați-vă că îl curățați în mod regulat și înlocuiți filtrul de aer după cum este necesar.

A fost util (207) Citeşte mai mult

Cum determin dimensiunea încălzitorului de care am nevoie pentru o cameră? Verificat

Dimensiunea încălzitorului de care aveți nevoie pentru o cameră depinde de dimensiunea camerei și de izolarea spațiului. O regulă generală este să utilizați 60 de wați pe metru pătrat de spațiu. De exemplu, dacă o cameră are 14 metri pătrați, un încălzitor de 840 de wați ar fi potrivit.

A fost util (172) Citeşte mai mult
Manual Tesy CN 03 100 MIS F Radiator

Produse asemanatoare

Categorii relevante

×
Download