Manual Panasonic ES-4032 Aparat de ras

Manual

7

How to remove the built-in

rechargeable battery before dis-

posal of the shaver

(see fig. 10)

The battery in this shaver is not

intended to be replaced by consum-

ers. However, the battery may be

replaced at an authorized service

center. The procedure described

below is intended only for removal of

the rechargeable battery for the pur-

pose of proper disposal.

Always make sure that the battery

have been removed from the shaver

before disposing of it.

1. Disconnect the power cord from

the AC outlet, and remove the

power cord from the shaver.

2. Remove the outer foil frame and

the inner blades.

3. Remove the trimmer driving bar

(a), and two screws (b).

4. Remove the screw (c) and the

bottom cover (d).

5. Remove the two screw covers (e)

(using something like a toothpick),

two screws (f), and the panel cov-

ers (g).

6. Remove the four screws (h), and

the back panel (i).

7. Remove the battery from the bat-

tery block (j).

Caution

• Do not charge the shaver where the

temperature is below 0°C (32°F) or

above 40°C (104°F), where it will

be exposed to direct sunlight or a

heat source, or where there is a lot

of moisture.

• Use only the included power cord

RE7-20 to charge the ES4032/

ES4033 shaver.

• Dry the shaver completely before

charging it.

• Keep the power cord away from

water and handle only with dry

hands.

• Grip the plug when disconnecting it

from an AC outlet; tugging on the

power cord may damage it.

• Store the power cord in a dry area

where it will be protected from dam-

age.

• Do not pull, twist, or severely bend

the power cord.

• Do not wrap the power cord tightly

around the appliance.

• The outer foil is very thin. If handled

improperly, it can be easily dam-

aged. To avoid personal injury, do

not use the shaver if it has a dam-

aged foil or inner blade.

• Place protective cap over shaver

head after use.

• Wash the shaver in tap water. Do

not use salt water or boiling water.

Also, do not use cleaning products

that are designed for toilets, bath-

rooms or kitchen appliances. Do

not submerge the shaver for a long

time.

• Do not wipe any part of the shaver

with thinner, benzine or alcohol.

Clean it by using a cloth dampened

with soapy water.

• Do not take the housing apart as

this can affect the watertight con-

struction.

• Do not clean with water when the

shaver is connected to the power

cord.

7

6

Cleaning your shaver

(see fig. 5)

For cleanliness and convenience, we

recommend that you clean your

shaver with water and a liquid hand

soap. Regular cleaning will keep your

shaver in good condition while pre-

venting odors or bacteria from devel-

oping, and maintain the cutting

performance.

With the outer foil in place, apply

some hand soap onto the outer foil.

Turn the shaver on and pour some

water over the outer foil.

After about 10-20 seconds, turn the

shaver off.

Remove the foil frame and clean it

with running water.

Wipe off any moisture from the

shaver with a dry cloth and remove

the protective cap to allow the outer

foil to dry completely.

Brush cleaning

Squeeze the outer foil release but-

tons and lift the outer foil upward to

remove it. Remove the inner blades

one at a time by grasping it firmly at

both ends and pulling it straight away

from the shaver (see fig. 7). Clean

the outer foils, the shaver body and

the trimmer with the long brush (see

fig. 8). Clean the inner blades with

the short brush by moving it in the

direction in fig. 9(A). Do not use the

short brush to clean the outer foils.

Replacing shaving head

components

It is recommended that you replace

the outer foil at least once a year and

the inner blades at least once every 2

years to maintain your shaver’s cut-

ting performance.

Replacing the outer foil

(see fig. 6)

Squeeze the outer foil release but-

tons and lift the outer foil upward to

remove it. To insert the new outer foil,

press down until it snaps into place.

Replacing the inner blades

(see fig. 7)

Squeeze the foil frame release but-

tons and lift the foil frame upward to

remove it. Remove the inner blade,

one at a time, by grasping them firmly

at both ends and pulling straight

away from the shaver. To insert the

new inner blade, hold the blade, one

at a time, at both ends and press

downward until it snaps into the

shaver.

For environmental protec-

tion and recycling of mate-

rials

This shaver contains Nickel-Metal

Hydride battery.

Please make sure that the battery is

disposed of at an officially assigned

location, if there is one in your coun-

try.

Warning – To prevent electric

shock or personal injury, discon-

nect the power cord from the

shaver and turn the shaver off

before cleaning.

6

P00-73.ES4032/4033̲eu  04.3.21 19:13  ページ6

Evaluare

Mai multe despre acest manual

Înțelegem că este plăcut să aveți un manual pe hârtie pentru Panasonic ES-4032 Aparat de ras. Puteți oricând descărca manualul de pe site-ul nostru web și îl puteți imprima singur. Dacă doriți să aveți un manual original, vă recomandăm să contactați Panasonic. S-ar putea să ofere un manual original. Căutați manualul dvs. Panasonic ES-4032 Aparat de ras într-o altă limbă? Alegeți limba preferată pe pagina noastră de pornire și căutați numărul de model pentru a vedea dacă îl avem disponibil.

Specificații

Toate manualele pentru Panasonic Aparate de ras
Mai multe manuale pentru Aparate de ras

Întrebări frecvente despre Panasonic ES-4032 Aparat de ras

Echipa noastră de asistență caută informații utile despre produs și răspunde la întrebările frecvente. Dacă descoperiți o inexactitate în întrebările frecvente, vă rugăm să ne anunțați utilizând formularul de contact.

Produse asemanatoare

Manual

Panasonic ES-4025 Aparat de ras

Manual

Panasonic ES-RT81 Aparat de ras

Manual

Panasonic ES-LV65 Aparat de ras

Manual

Panasonic ES-RT33 Aparat de ras

Manual

Panasonic ES-7101 Aparat de ras

Manual

Panasonic ES-LS6A Aparat de ras

Manual

Panasonic ES-8162 Aparat de ras

Manual

Panasonic ES-SA40 Aparat de ras

Categorii relevante