Manual EGO HT6510E Trimmer de gard viu

Manual

56 VOLT LITHIUM-ION CORDLESS HEDGE TRIMMER — HT5110E / HT6510E8

EN

Side Cutting

When trimming the sides of the hedge, begin at the

bottom and cut upwards as Fig. F shown. Trim the side of

a hedge so that it will be slightly narrower at the top. This

shape will expose more of the hedge to sunlight, resulting

in a more uniform growth.

Top Cutting

Use a wide sweeping motion. A slight downward tilt of the

cutting blades in the direction of motion gives the best

cutting results. For better cutting effect, you might as well

use the string to guide the hedge level as Fig. G shown.

Tip Protector (Fig. H)

The tip protector is used to protect the outer end of the

blade.

Blade Guard (Fig. I)

The outer part of the blades is shaped as blade guards.

WARNING: Always check that the blade guard is not

damaged or distorted. Replace it if it is bent or damaged.

MAINTENANCE

WARNING: When servicing, use only identical

replacement parts. Use of any other parts may create a

hazard or cause product damage. To ensure safety and

reliability, all repairs should be performed by a qualified

service technician.

WARNING: To avoid serious personal injury, always

remove the battery pack from the product when cleaning

or performing any maintenance.

CLEANING

◾ Use a soft brush to remove debris from all air intakes

and cutting blade.

◾ To remove pitch and other sticky residue, spray the

blades with resin solvent. Run the motor briefly so that

the solvent is evenly distributed, then wipe the surface

with a dry cloth.

WARNING: Avoid using solvents when cleaning

plastic parts. Most plastics are susceptible to damage

from various types of commercial solvents. Use clean

clothes to remove dirt, dust, oil, grease, etc.

SHARPENING THE BLADES

When cutting performance and behavior begin to

deteriorate, re-sharpen the blades. It is recommended

to have the blades re-sharpened by a qualified service

technician.

NOTICE:

Do not operate your hedge trimmer with dull or

damaged cutting blades. This may cause overload and

will give unsatisfactory cutting results.

LUBRICATING THE BLADE (Fig. J)

For best operation and longer blade life, lubricate the

hedge trimmer blade with light weight machine oil before

and after each use.

Remove the battery pack and lay the trimmer onto a flat

surface. Apply the oil along the edge of the top blade.

NOTICE: For extended using period, it is advisable to take

a break, remove the battery and oil the blades.

WARNING: Do not oil while the hedge trimmer is

running.

TRANSMISSION GEARS LUBRICATION (Fig. K)

The transmission gears in the motor housing need to

be lubricated periodically with gear grease. Check the

gear case grease level approximately every 50 hours of

operation by removing the sealing bolt.

K-1 Sealing Bolt

If no grease can be seen on the flanks of the gear, follow

the steps below to fill with about 5g gear grease. Do not

completely fill the transmission gear case.

1. Use a 4mm hex key (not included) to loosen and

remove the sealing bolt.

2. Use a grease gun (not included) to inject some grease

into the bolt hole; do not exceed 5g gear grease.

3. Tighten the sealing bolt after injection.

The grease should meet the following requirements:

- NLGI Grade Penetration: NLGI-2;

- Thickener Type: Polyurea;

- Recommended Operating Temperature Range: -40°C

to 180°C;

- Other than above, the grease should also be shear

stable with exceptional pressure characteristics and

excellent anti-wear property, and perfect oxidation

stability.

Evaluare

Mai multe despre acest manual

Înțelegem că este plăcut să aveți un manual pe hârtie pentru EGO HT6510E Trimmer de gard viu. Puteți oricând descărca manualul de pe site-ul nostru web și îl puteți imprima singur. Dacă doriți să aveți un manual original, vă recomandăm să contactați EGO. S-ar putea să ofere un manual original. Căutați manualul dvs. EGO HT6510E Trimmer de gard viu într-o altă limbă? Alegeți limba preferată pe pagina noastră de pornire și căutați numărul de model pentru a vedea dacă îl avem disponibil.

Specificații

Toate manualele pentru EGO Trimmere de gard viu
Mai multe manuale pentru Trimmere de gard viu

Întrebări frecvente despre EGO HT6510E Trimmer de gard viu

Echipa noastră de asistență caută informații utile despre produs și răspunde la întrebările frecvente. Dacă descoperiți o inexactitate în întrebările frecvente, vă rugăm să ne anunțați utilizând formularul de contact.

Produse asemanatoare

Manual

EGO HT2411E Trimmer de gard viu

Manual

EGO HT2400E Trimmer de gard viu

Manual

EGO HT6500E Trimmer de gard viu

Manual

EGO MHCC1002E Trimmer de gard viu

Manual

EGO HT5110E Trimmer de gard viu

Manual

EGO HT2410E Trimmer de gard viu

Manual

EGO HTX6500 Trimmer de gard viu

Manual

EGO HT2401E Trimmer de gard viu

Categorii relevante